Atomos Cable to feed both timecode and genlock from the UltraSync ONE to all RED cameras

Atomos Cable — feed both timecode and genlock from the UltraSync ONE to all RED cameras

This Atomos cable delivers both timecode and genlock signals from an UltraSync ONE to RED cameras. It lets you bring synchronized timecode and a reference video sync into RED camera systems using a single dedicated cable solution.

What this cable does

The cable carries timecode and genlock signals output by the UltraSync ONE and routes them into RED cameras. As a result, you can maintain frame-accurate timecode and stable genlock across your RED camera rig when you use the UltraSync ONE as your master sync source.

Who should consider this cable

• Filmmakers and camera operators shooting with RED cameras who use the UltraSync ONE for centralized timecode.
• Production teams that require synchronized timecode and genlock between multiple devices for multi-camera shoots.
• Anyone who needs a cable solution specifically intended to link the UltraSync ONE to RED camera systems.

Key features and benefits

• Feeds both timecode and genlock from the UltraSync ONE into RED cameras.
• Designed for use with RED camera systems to ensure compatibility with RED workflows.
• Simplifies on-set synchronization by providing the UltraSync ONE’s outputs directly to the camera.

Installation and typical use

Connect the cable between the UltraSync ONE and your RED camera to pass timecode and genlock. Then verify synchronization on each RED camera according to your camera’s monitoring and menu options. This cable integrates the UltraSync ONE into RED camera setups to help maintain consistent timecode and reference sync across shots.

Compatibility

The cable is intended to work with the UltraSync ONE as the source device and with all RED cameras as the target devices, enabling synchronized capture across RED camera models when used together.

FAQ

Question: Will this cable work with all RED cameras?
Answer: Yes, the cable is intended to feed timecode and genlock from the UltraSync ONE to all RED cameras.

Question: Can it carry both timecode and genlock at the same time?
Answer: Yes, the cable is designed to deliver both timecode and genlock signals from the UltraSync ONE to RED cameras simultaneously.

Question: Do I need any additional equipment to use this cable?
Answer: You need an UltraSync ONE as the source and a RED camera as the receiver. Whether you need additional adapters or accessories depends on your existing production setup and camera configuration.

Question: How do I confirm the camera is receiving timecode and genlock?
Answer: Check your RED camera’s monitoring and menu indicators for incoming timecode and genlock status after connecting the cable and powering your devices.