Datavideo CB-3 20m Intercom extension Cable 5 pin XLR

Datavideo CB-3 20m Intercom Extension Cable – 5-pin XLR for ITC-100 and ITC-100SL

The Datavideo CB-3 extension cable provides a simple way to extend intercom connections between compatible Datavideo units. It uses a 5-pin XLR connector and measures 20 meters, giving you additional reach when placing intercom stations further apart.

Key features

• 20M Intercom Extension Cable
• 5 pin XLR connector
• For use between ITC-100 and ITC-100SL

Each feature above describes the core attributes of the CB-3. First, the 20m length lets you position intercom stations at greater distances. Second, the cable uses a 5-pin XLR connector, which matches the intercom connector type used by the supported units. Finally, the CB-3 is intended for direct use between the ITC-100 and ITC-100SL models.

Compatibility and use cases

The CB-3 is made to connect Datavideo ITC-100 and ITC-100SL intercom units. Therefore, it works when you need to extend the wired intercom link between those two models. If you plan to place your intercom stations further apart in a studio or on location, this extension cable provides the required length while keeping the original connector type.

Practical notes

When installing, simply connect the 5-pin XLR ends to the corresponding ports on the intercom units. Because the cable is 20 meters long, it helps bridge longer distances without replacing your existing intercom wiring. If you have any questions about routing or compatibility with other equipment, consult the intercom manuals or contact support.

Specifications

FAQ

Question: Can I use the CB-3 with other intercom or XLR equipment?
Answer: The CB-3 uses a 5-pin XLR connector and is specified for use between the ITC-100 and ITC-100SL. If you want to use it with other equipment, check that the device uses the same 5-pin XLR wiring and connector configuration before connecting.

Question: Does the CB-3 carry power or only audio signals?
Answer: The CB-3 is described as an intercom extension cable with a 5-pin XLR connector. Whether it carries power as well as audio depends on the intercom system design (ITC-100/ITC-100SL). Refer to your intercom unit documentation to confirm which signals travel through the 5-pin XLR connection.

Question: Is the 20m length suitable for outdoor or long-run installations?
Answer: The cable length is 20 meters, which provides extended reach for studio or location use. For outdoor installations or specific environmental needs, verify any temperature, abrasion, or weather-resistance requirements and consult product documentation or support if necessary.